A SIMPLY INSTALLATION GUIDE LINE ON HOW TO FIT AND INSTALL CARBON FIBRE STICKERS SHEETS ONTO YOUR MOTOR VEHICLE

HOW TO APPLY CARBON FIBRE?

STEP 1:

Buy a sheet of carbon vinyl sticker

cut sheet to allow approximately 50mm overlapp around edges of surface/vehicle panel

STEP 2:

clean surface and ensure that grease, dirt and polish is removed from panel and most importantly the inner-edge of the panel

use sunlight liquid to clean surfaces of panels.

STEP 3:

apply just plain water on the panel and also on the sticky side of the carbon vinyl sticker, using a water spray bottle.

STEP 4:

apply carbon fibre onto vehicle and then using an applicator or credit card, applicate the water out from the carbon fibre (similar to tinting a car window).By doing this we are removing all water and air bubble from the carbon fibre.

STEP 5:

Then cut off ur edges and use a heatgun or a hair dryer to seal the edges.